VOLTCRAFT 20 00 80 (CT-8000Pb) Bedienungsanleitung Seite 44

An arrow blinks next to it and the measured accumulator voltage is displayed. If
charging currently takes place, the arrow points upwards; during discharging, the
arrow points downwards.
The second line indicates the processing time in hh:mm which has already been
passed. If 100 hours are reached, the time will be set back to 00:00 (the WINTER
programme is almost the only one in which this may happen). The charge and dis-
charge current is also displayed.
If a voltage has not been ascertained yet, the following display appears
"23° C >U= --.---V"
With the program WINTER, the lapsed waiting time appears in the break as D=
DAYS/hh:mm. Then, an arrow is flashing before „T".
"BREAK>T=29/23:59"
If the accumulator is almost completely charged, the second line shows a hook
instead of the lapsed time.
"CHA S>C= 17.4mAh"
"(3) D= 0.0mAh"
If the accumulator was almost completely charged, you can stop the pro-
gram by pressing ESC. If you now press OK, READY appears (and not
ERROR).
" PRESS <OK> TO
" END PROGRAM
If a programme has been successfully carried out, RDY (for READY) appears and the
arrow stops flashing.
"RDY S C= 34.29Ah"
"08:51 D= 31.67Ah"
"23° C U= 13.242V"
"08:51 D= 96% S "
Apart from the time required, the capacity of the accumulator is given in percent.
This value is based on the capacity „D" taken and the entered accumulator capacity.
As no discharge takes place in the CHARGE and the PUSH program, a zero is given
here. At the end of the programs CHECK, CYCLE, ALIVE or WINTER, the residual
charge is added to the taken capacity (values of above 100% are not possible).
44
"
"