VOLTCRAFT 20 00 80 (CT-8000Pb) Bedienungsanleitung Seite 29

This device has left our factory in impeccable condition.
To maintain this status and ensure safe operation, the user must comply with the
safety instructions and warnings contained in these operating instructions. The fol-
lowing symbols must be observed:
This equipment is CE-tested and thus meets the EMC directive
89/336/EEC and the low-voltage directive 73/23/EEC.
Protection class 2 (double insulated)
Only for use in dry interior environments.
For safety and licensing reasons (CE), unauthorized conversion and/or modification
of the device is not permitted.
Consult suitably qualified staff, if you have doubts about how the equipment oper-
ates or about how to connect it safely.
Measuring instruments and accessories are not toys and have no place in the hands
of children!
In commercial institutions, the accident prevention regulations of the relevant trade
associations for electrical systems and operating materials are to be observed.
In schools, training centres, computer and self-help workshops, handling of measur-
ing devices must be supervised by trained personnel in a responsible manner.
Prior to each setup, check your charging device and its cables for damage(s). Never
use the device if the protective insulation is damaged (ripped, torn off etc.).
Do not operate the charging station in areas or unfavourable conditions where com-
bustible gases, vapours or dust are or may be present.
If you have reasons to assume that the safe operation is not possible any longer,
take the device out of operation immediately and protect it against inadvertent oper-
ation. Reasons to assume that the safe operation is not possible any longer include
the following ones:
- the device is visibly damaged,
- it does not function any longer and
- if it has been stored for long periods of time under unfavourable conditions
- if it has been subject to considerable stress in transit.
29