VOLTCRAFT 20 00 80 (CT-8000Pb) Bedienungsanleitung Seite 34

"PROGRAM
"1. CHA-CHARGE "
"2. CHK-CHECK
"3. CYC-CYCLE
"4. ALV-ALIVE
"5. WIN-WINTER "
These programmes cope with the following tasks:
CHA-CHARGE means that the accumulator connected will be charged.
CHK-CHECK means that the accumulator will be discharged and recharged.
CYC-CYCLE means that the accumulator connected will be first charged, then dis-
charged and finally charged anew.
ALV-ALIVE means that the accumulator will be charged and discharged, then
recharged and discharged again and finally charged anew. The ALIVE programme is
used for activating new accumulators and such ones which have been stored over a
longer period of time.
WIN-WINTER serves to enable lead accumulators to overcome the winter. The WIN-
TER programme simulates the practical use. The accumulator is discharged down to
approximately 40% of its capacity and then charged up to 80% of its capacity. After-
wards, the device will not be used during the period of time you have selected (three
to 30 days). This process is repeated till the battery will be disconnected,
Note: If you need an accumulator during the following days, exit the
WINTER programme and start the CHARGE programme!
CHA-CHARGE
CHK-CHECK
CYC-CYCLE
ALV-ALIVE
WIN-WINTER
Now, the discharge mode is to be defined. Two discharge options are available.
As in the CHARGE program the accumulator is only charged, this menu point is
skipped in the CHARGE program and the charge program starts immediately.
"SET DIS-MODE
"1. AUTOMATIC
"2. MANUAL Umin"
34
"
"
"
"
= charge only once
= discharge - charge
= charge - discharge - charge
= charge - discharge - charge - discharge - charge
= discharge - charge - pause - discharge - charge - pause...
"
"