C) Inserting The Battery, Selecting The Operating Mode, Setting The Charging Current; D) Subsequently Changing The Operating Mode Or Charging Current For A Single Battery Slot - VOLTCRAFT CC-2 Bedienungsanleitung

c) Inserting the battery, selecting the operating mode, setting the
charging current
• Insert a suitable rechargeable battery into any battery slot (2), observing the correct polarity
(note positive/+ and negative/-, see the label in the battery compartment and on the battery).
Due to the design/size of batteries of type C, only two of the four battery slots can be
used.
• The voltage of the battery appears on the corresponding LC display and the "CHARGE"
operating mode flashes for four seconds. During this time, you can press the "MODE" key (6)
repeatedly to select the operating mode.
• "300 mA" is then displayed as the charging current and the operating mode "CHARGE" or
"CHARGE TEST" flashes. During this time, you can press the "CURRENT" key (4) repeatedly
to select the charging current.
• When no button has been pressed for a few seconds, the charging process starts.
If, after inserting the battery, no voltage is displayed, either the battery contacts have
oxidised or are highly resistive, or the battery has discharged deeply or is faulty.
Whether or not a different operating mode can be selected or the charging current can
be changed, please refer to Chapter 8. d) and 8. e).
d) Subsequently changing the operating mode or charging current
for a single battery slot
• Press the control key (3) for the respective battery slot whose operating mode or charg-
ing/discharging current you want to change. The corresponding indicator on the LC display
flashes (press the control key for the battery slot 2x, if necessary).
• Select the operating mode by briefly pressing the "MODE" key (6).
• Change the charging current by briefly pressing the "CURRENT" key (4).
• Wait a few seconds, the settings are applied.
31