Operating Instructions - Cambridge Audio azur 540R V2.0 Bedienungsanleitung

OPERATING INSTRUCTIONS

To activate the 540R V2.0, switch the Power button on the rear panel to
On then press the Standby/On button on the front panel.
Selecting t t he s s ource
1. Select the desired source by pushing the corresponding source
button on the front panel or remote control.
2. Press the Input Mode button to select the input mode of the source
equipment, either analogue or digital (depending on the connection
made on the rear panel).
If you are connecting your source equipment digitally (via optical or
coaxial connections) and "UNLOCK" appears on the display, the source
is either not connected properly or the source is not switched on.
The 540R V2.0 stores the input type for each source so that it is
automatically recalled when that source is selected again.
Selecting t t he d d esired l l istening m m ode
Select the appropriate mode for the source material you are listening to
by pressing the appropriate front panel button and cycling through the
available sub-modes. 5 Types of operation are possible:
Stereo - selects 2 channel Stereo (with or without subwoofer) operation
for stereo material. This mode is for use with the analog outputs from
Tuner's or CD Players etc or un-encoded stereo digital outputs (LPCM)
i.e. from a CD players SPDIF output.
Dolby D D igital E E X / / D D TS E E S M M ode - selects a range of digital surround
modes in (up to) 5.1 or 6.1 with the appropriately digitally encoded
26 Azur AV receiver
material. These modes are for use with the digital outputs
(Bitstream/Raw) from DVD players or satellite receivers SPDIF outputs
etc.
Dolby P P rologic I I I / / N N eo:6 m m ode - selects a range of analog surround
modes in (up to) 5.1 or 6.1 with appropriate analog encoded material.
These modes are for use with the analog outputs from TV's or VCR
Players if the source material has been encoded using one of these
processes.
DSP m m ode - selects a range of Digital Signal Processing modes which
can generate a realistic surround sound experience from material
without actual surround sound encoding. These modes are for use with
the stereo analog outputs from Tuner's or CD Players etc or un-encoded
stereo digital outputs (LPCM) i.e. from a CD players SPDIF output.
Using t t he T T uner
1. Press the Tuner FM/AM button on the front panel or remote control
to select Tuner mode.
2. Press the Tuner FM/AM button again to select FM or AM if desired.
3. Press the Mode/Store button on the front panel (or Mode button on
the remote control) to select automatic tuning, manual tuning or
preset mode.
4. Press the Tuning + and Tuning - buttons (or the left and right arrow
buttons on the remote) to select the station you want to listen to
In automatic tuning mode the unit scans to the next strong station. In
manual tuning mode the user can step manually through the
frequencies. In preset mode the unit cycles through the presets only.