Remote Control - Cambridge Audio azur 540R V2.0 Bedienungsanleitung

REMOTE CONTROL

The 540R V2.0 is supplied with an Azur Navigator remote control.
Insert the supplied AAA batteries to activate. For full details of the
various adjustment functions available from the remote, refer to
the later sections of this manual.
Standby/On
Switches the unit between On and Standby mode.
Input M M ode
Switches the 540R V2.0 between analog and digital inputs for the
currently selected source.
Stereo, PLII/NEO 6 6 , D D D E E X/DTS E E S, D D SP M M ode
See button details as listed in the 'Front Panel Controls' section.
Dynamic
Press repeatedly to reach the desired dynamic compression range
(Dolby Digital mode only).
LFE T T rim
Press to access the Low Frequency Trim (subwoofer) mode.
Test T T one
Press to access the test tones to balance your surround sound
speakers.
12 Azur AV receiver
CH S S elect
Input
Mode Press to select individual channels, then use volume to balance
speakers.
PL II DD EX
Stereo
Neo 6 DTS ES
Sub O O n/Off
DSP LFE
Dynamic
Mode Trim
Press to turn on/off the output of the subwoofer.
Test CH Sub
Tone Select On/Off
SPK
Delay Delay
Setup
Press to set the delay times when setting up surround sound
speakers.
Vol
SPK S S etup
Enter
Press to change the surround sound speaker settings.
Vol
On-s s creen D D isplay ( ( OSD)
Tuner Bass 6.1
AM/FM Treble Direct
Press to access an on-screen set-up menu when connected to a
PTY APS Display
monitor/screen via composite or S-video connections.
Stereo
Store Mode
Mono
Mute
DVD Video 1 Video 2
Tape CD
Video 3 Mutes the audio on the AV Receiver. The mute mode is indicated
MD/CDR Aux
by the channel LED flashing. Press again to cancel mute.
Volume
Increase or decrease the volume of the AV receiver output. Also
used as up/down in the OSD setup menu.