ATH-Heinl Four Lift 64AP Bedienungsanleitung Seite 73

Control box
This is where the complete electrical control system is located. All buttons are protected by a front ring to prevent unintentional
operation. Furthermore, all movements are immediately interrupted when the buttons are released (dead-man control).
Hydraulic unit
Here, the hydraulic oil is fed from the tank through a gear pump, which is driven by the electric motor, to the lifting cylinder. The
oil can flow back to the tank via the lowering valve.
Pawls
They prevent the platform from descending more than 100 mm in case of any deficiency and keep the platform in the parking
position. Pneumatic cylinders unlock the device each time a lowering is performed.
Rope break safety switch
Drive-on ramps with roll-off protection function
This device prevents the vehicle from rolling down when raised.
Roll-off protection
This device prevents the vehicle from rolling down when raised.
CE stop
This device stops the platform during downward movement at a height of 400 mm.
4
3
1
2
Ventilated tank cap
Oil tank
Solenoid valve
Engine
® Copyright ATH-Heinl GmbH & Co. KG / All rights reserved / Misprints and technical changes reserved
Release date: 02.06.2023 / Product manufacturer ATH-Heinl GmbH & Co. KG
73