ATH-Heinl Four Lift 64AP Bedienungsanleitung Seite 72

1.2 Description
12
5
1
7
8
13
10
Main lifting column
The two crossbeams are guided in the lifting columns during lifting and lowering. The lifting columns are used to anchor the
lifting platform to the floor.
Detent rod
The detent rods are used to engage the pawls in the parking position and in the event of a fault.
P1 Main rail
The main rails bridge the two crossbars. They are the parts of the platform onto which the vehicle is driven. The hydraulic
cylinder and the mechanisms required to transmit the lifting forces (ropes, rollers, etc.) are located under the main travel rail.
The travel rails are equipped with swing plates at the rear and recesses at the front (without empty plates) for axis measuring
turntables.
P2 Secondary rail
It is constructed in the same way as the main guideway, but does not contain any hydraulic functional parts. It is loosely
mounted on the cross members on one side and can be adjusted according to the track width of the vehicle.
Crossmembers
The crossbeams are the supporting parts of the platform, with which the opposite pairs of columns are connected. Both drive-
on ramps are attached to these crossbars.
Wheel alignment kit
The rails are additionally equipped with swing plates at the rear and recesses at the front (without empty plates) for wheel
alignment turntables.
® Copyright ATH-Heinl GmbH & Co. KG / All rights reserved / Misprints and technical changes reserved
72
3
Release date: 02.06.2023 / Product manufacturer ATH-Heinl GmbH & Co. KG
9
4
6
2
11