Introduction To Working With Plastcoat Hp 30; Function Of The Plastcoat Hp 30; Processible Coating Materials; Technical Data - WAGNER PLAST COAT HP 30 Originalbetriebsanleitung

Plast Coat HP 30
2
INTRODUCTION TO WORKING WITH
PLASTCOAT HP 30
PlastCoat HP 30 is designed for the use and processing of
ready-mixed mineral or paste-like coating materials.
The machine is not designed for use as a cleaning device.
2.1

FUNCTION OF THE PLASTCOAT HP 30

The coating material is supplied by means of the contain-
er. The spiral conveyor feeds the coating material to the ec-
cen-tric screw pump. The suction effect causes the coating
material to enter the eccentric screw pump. This pump builds
up the pressure required for transportation through the hose.
The coating material flows to the spray gun and is atomised as
it exits the nozzle.
A soft even spray pattern can be achieved by means of the
smoothly regulated convey capacity of the coating material.
2.2

PROCESSIBLE COATING MATERIALS

• Airless filling compounds (max. grain size 0.3 mm)
• Dispersion filling compounds (max. grain size 0.3 mm)
• Outdoor and indoor water-based dispersion paints*
• Water-based primers*
* To process this material, the dispersion set (Art. No. 2400684 )
will be needed.
When processing spray filler and similar ma-
terials, do not use a gun filter as the filter can
otherwise become blocked.
All the coating materials must be suitable for machine pro-
cessing. Refer to the product data sheet of the coating mate-
rial to be processed.
For cleaning and maintenance, only use liquids approved by
Wagner.
Stir the coating material well before starting
work to optimise its flow properties.
Make sure, when stirring up with motor-dri-
ven agitators that no air bubbles are stirred in.
Air bubbles disturb when spraying and can, in
fact, lead to interruption of operation.
Warm material can be processed better (room
temperature recommended).
Use other coating materials only after agreement with the
manufacturer or the WAGNER application technology service.
3

TECHNICAL DATA

Voltage:
Fusing:
Device supply cable:
Motor output P :
1
Max. convey capacity (water):
Max. convey capacity (Airless
dispersion spray putty):
Max. operating pressure:
Dimensions L x W x H:
Container capacity:
Weight:
Max. tyre pressure:
Degree of protection:
Max. sound pressure level:
Max. high pressure hose length: 20 m (and 2.5 m hose
Required diameter of high
pressure hose:
Max. delivery height:
* Measured in accordance with VDMA 24284
** Place of measurement: 1 m distance from unit and 1.60 m
above reverberant floor.
EN
INTRODUCTION
PlastCoat HP 30
230 V~, 50/60 Hz
16 A time-lag
5 m long, 3 x 2.5 mm
2
2.3 kW
6.8 l/min
10 kg/min *
12.0 MPa (120 bar)
1220 x 550 x 620 mm
50 l
72 kg
2.5 bar
IP 54
70 dB (A)**
whip), 10 m recommended
DN 19 (fillers)
DN 10 (dispersion paints)
20 m
29