Safety Regulations; Cleaning And Maintenance - WAGNER PLAST COAT HP 30 Originalbetriebsanleitung

Plast Coat HP 30
1

SAFETY REGULATIONS

The following sources are just a sample of those containing
safety requirements for mortar conveyors:
a) EN 12001, Conveying, spraying and placing machines
for concrete and mortar - Safety requirements
All local safety regulations in force must be observed.
The following specifications are to be observed in particular to
handle machines safely:
Usage of the machine
The PlastCoat HP 30 may only be used to process the
coating materials described on page 29. Any other us-
age is not allowed.
Proper usage also includes the observance of the operating
manual and the observance of the inspection and mainte-
nance conditions. Always keep the operating manual on hand
at the point of use of the machine.
The PlastCoat HP 30 may only be operated with a manometer.
Only the mortar hose specified by the manufacturer may be
used.
Use only marked mortar hoses with at least 120 bars operat-
ing pressure.
Only use original Wagner spare parts and accessories.
The machine is intended exclusively for commercial use by
professionals.
Protection of persons
In order to protect eyes, skin and the respiratory organs: Wear
safety goggles, protective clothing, gloves, possibly use
protective skin cream and respiratory equipment. Do not
decouple the high pressure hose as long as it is under pres-
sure. Watch the manometer! Wear safety goggles! Do not
point the spray gun at persons!
In order to protect your ears wear ear protection.
Wear safety shoes when transporting the machine or working
with it.
People not needed to assist with machine installation, assem-
bly or operation, must keep away from the machine.
Always secure the spray gun when fitting or dismantling the
nozzle and if temporarily stopping work.
When using a high operating pressure,
pulling the trigger guard can effect a recoil
force up to 15 N.
If you are not prepared for this, your hand
can be thrust backwards or your balance lost.
This can lead to injury.
The PC HP 30 is equipped with an EMERGENCY STOP switch
for emergencies.
Breathing masks
Make a breathing mask available to the processor in order to
protect against mineral dust.
Connection to the mains network only via a special feed-
ing point, for example via a distribution board for con-
struction sites, with residual current protective device
with INF ≤ 30 mA.
Risk of injury from escaping material.
Before switching on, always check that the
trigger guard on the spray gun is secured.
Secure the trigger guard whenever work is
interrupted.
Never operate the machine if the rotor is
exposed or if the container has been re-
moved.
Do not reach into the rotor when it is mov-
ing. Risk of crushing.
Caution if you have long hair. Only wear
close-fitting clothes at work.
Do not insert objects or body parts
through the protective grid.
Risk of crushing when folding in the han-
dles, assembling the pump unit and con-
necting the mortar hose.

Cleaning and maintenance

Never decouple high pressure hose or disassemble machine
when under pressure. Note pressure reading on pressure
gauge.
When performing maintenance work, always switch off ma-
chine, disconnect mains plug and ensure it cannot be plugged
back in by mistake.
Do not spray down the motor and control unit of the machine
with a water-jet, high-pressure cleaner or high-pressure steam
cleaner. Danger of short-circuits caused by water ingressing.
Electrical equipment
Work on the machine's electrical equipment may be carried
out only by a qualified electrician. The electrical equipment is
to be checked regularly. Eliminate faults such as loose connec-
tions or scorched cables.
Keep the stickers and notices on the machine clean and
legible.
Whenever the machine is automatical-
ly brought to a standstill or during pow-
er failure, immediately move the selec-
tor switch to "0" to prevent the machine
starting back up again unintentionally.
There is a danger of injury.
EN
SAFETY REGULATIONS
27