Use Of Units On Building Sites And Workshops; Ventilation When Spraying In Rooms; Suction Installations; Earthing Of The Object - WAGNER SUPER FINISH 23 CR Betriebsanleitung

Super Finish 23 CR
2.12
USE OF UNITS ON BUILDING SITES AND
WORKSHOPS
The unit may only be connected to the mains network via a
special feeding point with a residual-current device with INF
≤ 30 mA.
2.13

VENTILATION WHEN SPRAYING IN ROOMS

Adequate ventilation to ensure removal of the solvent vapors
has to be ensured.
2.14

SUCTION INSTALLATIONS

The are to be provided by the unit user in accordance with the
corresponding local regulations.
2.15

EARTHING OF THE OBJECT

The object to be coated must be earthed.
(Building walls are usually earthed naturally)
2.16

CLEANING THE UNIT WITH SOLVENTS

When cleaning the unit with solvents, the
solvent should never be sprayed or pumped
back into a container with a small opening
(bunghole). An explosive gas/air mixture can
arise. The container must be earthed.
2.17

CLEANING THE UNIT

Danger of short-circuits caused by water in-
gression!
Never spray down the unit with high-pres-
sure or high-pressure steam cleaners.
2.18
WORK OR REPAIRS AT THE ELECTRICAL
EQUIPMENT
These may only be carried out by a skilled electrician. No li-
ability is assumed for incorrect installation.
2.19

WORK AT ELECTRICAL COMPONENTS

Unplug the power plug from the outlet before carrying out
any repair work.
2.20

SETUP ON AN UNEVEN SURFACE

The front end must always point downwards in order to avoid
sliding away.
If possible do not use the unit on an inclined surface since the
unit tends to wander through the resulting vibrations.
3

GENERAL VIEW OF APPLICATION /

DESCRIPTION OF UNIT
3.1

APPLICATION

Super Finish 23 CR is an electric driven unit for the airless at-
omization of different painting materials. The Super Finish 23
CR is also great for processing injection foams and injection
resin.
Super Finish 23 CR is made for jobs in the workshop and on
the building site.
The unit performance is conceived so that its use is possible
on building sites for small- to middle-area dispersion work.
When painting, the device is suitable for all kinds of typical
painting jobs, e.g.:
doors, door frames, balustrades, furniture, woodencladding,
fences, radiators (heating) and steel parts.
We recommend using the top container for paintwork.
EN
SAFETY REGULATIONS
29