Inhaltsverzeichnis
Werbung
▪ Control car settings (only for 5510002 / 5520002)
Dear customer!
1. A PluX multiprotocol decoder has already been installed in your control
car. If you change one of these CVs on the matching locomotive, you have
to do the same on the control car.
2. The end car of this Railjet set includes an electrically conductive coupling.
If you would like to combine this with a locomotive with a NEM shaft,
please use the enclosed coupling adapter.
3. For Motorola
®
"2
Motorola
address". This is one higher than the base address (CV1)
nd
®
and is enabled at delivery.
DCC/NMRA
Factory setting
1
3
2
1
3
12
4
12
5
252
6
120
6
8 Reset
17
192
18
0
29
6
F0 = Front / rear light on the control car
F5 = High beam (also accessible via 2
F6 = Shunting mode
F7 = Interior lighting (also accessible via 2
carriages
5500002.indd 33
5500002.indd 33
drivers: You can enable function keys F5 and F7 via the
Motorola
nd
Motorola
nd
Function mapping (CV33-CV46, CV61)
33
1
34
2
35
0
36
0
37
0
38
0
39
4
40
0
41
8
42
0
43
0
44
0
45
0
46
0
58
0
61
97
124
3
155
6
156
6
address: F1) on the control car
®
address: F3) on the control car and on all attached
®
33 33
33
17.07.2023 11:17:18
17.07.2023 11:17:18
Werbung
Inhaltsverzeichnis
