Inhaltsverzeichnis
Werbung
Preparation
Inserting the oven
WARNING
Risk of electric shock!
Incorrect installation/dismantling can
cause electric shock.
• Before installing/dismantling the
appliance, check that the socket to
which the appliance is connected is
switched off.
NOTICE
Risk of damage!
Improper handling of the appliance
can result in damage.
• Use only the side carry points to lift
the oven.
• Do not set the oven down on the
edge or corner of the oven door! The
glass panes can be damaged.
1. Push the oven into the recess until the front
fascia is flush with the installation unit.
The mains connection must not be kinked,
pinched or otherwise damaged.
2. Ensure an even gap between the oven and
the unit walls on both sides. Do not seal the
gap above the oven fascia.
Built-in oven with digital timer 65M90D0-E11319G
G B - 1 4
19
3. Once the oven is correctly positioned, open
the oven door and screw into the unit using
the fitting screws 19 supplied.
4. Switch the socket fuse back on.
5. Check the functions as described from page
GB-15.
Removing the oven
1. Switch off the socket for the Ovenbefore re-
moval. To do this, unscrew and/or switch off
the fuse for the socket.
2. Remove the two fixing screws 23.
3. Lift the rear of the appliance and only pull it
out slightly at first. Then grab onto the side
recessed grips 2 and pull it out completely.
4. Pull the mains plug out of the socket.
Werbung
Inhaltsverzeichnis
