Hardware Settings (Dip Switches) - Endress+Hauser OTMT84 Bedienungsanleitung

Operation and commissioning
Device description files
®
PROFIBUS PA protocol (IEC 61158-2, MBP):
Valid for firmware/software:
®
PROFIBUS PA device data
Profile version:
TMT84 device ID:
Profile ID:
GSD information
TMT84 GSD:
Profile GSD:
Bitmaps:
Operating program/device
driver:
GSD
FieldCare/DTM
SIMATIC PDM
5.4

Hardware settings (DIP switches)

DIP switches on the rear of the display are used to enable and disable hardware write protection,
configure the device address and to switch (turn) the display 180°. When write protection is
active, parameters cannot be modified.
The simulation mode via the hardware setting must be changed before the software setting.
To set the DIP switches, proceed as follows:
1. Remove the attached display from the head transmitter.
2. Configure the DIP switch on the rear of the display accordingly.
Generally: switch to ON = function enabled, switch to OFF = function disabled.
3. Fit the display onto the head transmitter in the correct position. The head transmitter
accepts the settings within one second.
40
1.00.zz
3.01
1551
hex
Depending on the profile GSD file used:
0x9703, 0x9702, 0x9701 or 0x9700
Extended
PA139700.gsd
PA139701.gsd
PA139702.gsd
PA139703.gsd
EH1551_D.bmp/.dib
EH1551_N.bmp/.dib
EH1551_S.bmp/.dib
Source for device descriptions/program updates, free downloads on Internet:
• www.endress.com (→ Download → Software → Device Drivers TMT84)
• www.profibus.com
• www.endress.com (→ Download → Software → Device Drivers TMT84)
• www.endress.com (→ Download → Software → Device Drivers TMT84)
• www.fielddevices.com
Dual-input temperature transmitter
1.01.zz
3.02
Compatibility matrix:
| EH3x1551.gsd | EH021551.gsd
1.00.zz | OK |
1.01.zz | OK |
*Can be used if the "C1_Read_Write_supp = 1" entry in
the GSD is set to "C1_Read_Write_supp = 0".
STOP*
OK