Safety Systems; Overview - Bosch MUM57-Serie Gebrauchsanleitung

en Important safety information
W Explanation of the symbols on the appliance or accessory
i
Follow the instructions in the operating instructions.
Y
Caution! Rotating blades.
W
Caution! Rotating tools. Do not place fingers in the feed tube.
Congratulations on the purchase of
your new Bosch appliance. You can find
further information about our products
on our web page.
Contents
Intended use .............................................. 22
Important safety information ...................... 22
Safety systems ........................................... 24
Overview .................................................... 24
Operating positions .................................... 25
Operation ................................................... 26
Cleaning and servicing ............................... 29
Storage ....................................................... 30
Troubleshooting ......................................... 30
Application examples ................................. 31
Special accessories ................................... 32
Disposal...................................................... 32
Guarantee .................................................. 32

Safety systems

Start lock-out
See "Operating positions" table.
The appliance can be switched on in
pos. 1 and 3 only:
■ when the bowl (11) has been inserted
and turned until it locks into place.
Restart lock-out
If the power is interrupted, the appliance
remains switched on but the motor does
not start running again when the power
is restored. To switch the appliance on
again, turn the rotary switch to P, then
switch on.
24
Overload protection
If the motor switches itself off while the
appliance is being used, the overload
protection feature has been activated.
A possible cause may be that too much food
was processed at one time.
If a safety system is activated, see
"Troubleshooting".
The appliance requires no maintenance.

Overview

Fig. A
Base unit
1 Release button
2 Swivel arm
"Easy Armlift" function to support
the upward movement of the arm
(see "Work positions").
Rotary switch
When the appliance has been switched
off (position P), the appliance runs
automatically to the optimum position for
changing the tools.
P = Stop
M = Instantaneous switching at
maximum speed, hold switch for required
blending duration.
Settings 1-7, Operating speed:
1 = low speed - slow,
7 = high speed - fast.
3 On/Off display
Is lit while the appliance is operating
(rotary switch on M or 1-7). Flashes if the
appliance has been operated incorrectly,
the electronic fuse has tripped or the
appliance is defective - see section
"Troubleshooting".