Storage; Transport; Spare Parts Order - Scheppach SG1500i Originalbetriebsanleitung

Spark plug (Fig. 4)
Check the spark plug after the first 20 hours of use
for dirt and if necessary clean it with a copper wire
brush. Then service the spark plug after every 50
hours of use.
• Remove the cover.
• Remove the spark plug connector (16) with a
turning movement.
• Remove the spark plug with the spark plug
socket (E) included.
• Put it back together in the opposite order.
Petrol filter (Fig 8+9)
Note: The petrol filter (22) is a filter bowl located
directly under the petrol cap (2) , filtering any petrol
added.
1. Turn the on /o ff switch (10) to the "OFF" position.
2. Open the petrol cap (2)
3. Remove the petrol filter (22) and clean in a
nonflammable solvent or solvent with a high
flash point.
4. Reinsert petrol filter (22).
5. Close the petrol cap (2).
Changing the oil (Fig. 5)
If the petrol engine operates frequently under high
temperatures or high loads, change the oil every 25
hours.
Changing the oil should take place when the engine
is warm.
WARNING! Drain fuel before replacing the oil.
Only use engine oil (15W-40).
• Always set up the device on a level and stable
surface. Do not operate the generator on forest
soil, which radiates heat during operation and
in the cooling phase and can ignite flammable
materials!
• Remove the screws and the cover (5).
• Open the oil filler cap (17) and drain the warm
engine oil into a container by tilting the genera-
tor.
• Pour in engine oil (approx. 0.28 litres).
• Close the cover (5) and tighten the screws.
Low oil switch off
The low oil switch-off responds, if there is not enough
engine oil. The oil check bulb (12) starts to flash
when there is insufficient oil in the motor. The check
bulb begins to flash when the oil amount has gone
below the safe level. The engine will turn off indepen-
dently after a short time. Restart is possible only after
pouring in more engine oil.
 www.scheppach.com /  service@scheppach.com /  +(49)-08223-4002-99 /  +(49)-08223-4002-58

10. Storage

Preparation for storage
• Empty the petrol tank with a petrol suction
pump. Remove fuel filter and drain the carburet-
tor.Loosen the screw on the lower side of the
carburettor and drain the petrol into a receptacle
provided for this purpose..
Warning notice: Do not remove fuel in closed
rooms, close to fire or whilst smoking. Vapours
can cause explosions or fires.
• Start the engine and leave it running until the
rest of the petrol has been used up.
• Store fuel in tanks specifically designed for this
purpose.
• Change the oil after each season. To do this, re-
move the old oil from the warm engine and refill
with new oil.
• Remove the spark plug. Fill about 20 ml of oil into
the cylinder using an oil can.
• Slowly pull the express start so that the oil pro-
tects the cylinder from the inside.
• Screw the spark plug back in
• Store the device in a well ventilated place or area.

11. Transport

Preparation for transporting
• Empty the petrol tank with a petrol suction pump
or alternatively using the petrol tap and a suitable
canister.
• Once it is ready for use, leave the engine running
until the rest of the petrol has been used up.
• Empty the engine oil from the engine (as de-
scribed).
• Remove the spark plug connector (16) from the
spark plug.
• Secure the device with a tension belt to prevent
it slipping out of place.
• The generator can be lifted and carried by using
the handle.

12. Spare parts order

Service information
Please note that the following parts of this product
are subject to normal or natural wear and that the
following parts are therefore also required for use as
consumables.
Wear parts*: spark plug
* Not necessarily included in the scope of delivery!
GB | 23