Storage; Maintenance - Scheppach SG7100 Serie Original Bedienungsanleitung

12. Storage

Store the device and its accessories in a dark, dry and
frost-free place that is inaccessible to children. The op-
timum storage temperature lies between 5 and 30 ˚C.
Store the power tool in its original packaging. Cover the
power tool to protect it from dust or moisture. Store the
operating manual with the power tool.
When storing for a long period of time
1. Empty the fuel tank and run the carburettor empty.
2. Unscrew the spark plug.
3. Approx. Pour approximately 20 ml of clean engine
oil through the spark plug hole into the cylinder.
4. Pull the starter rope out slowly so that the oil dis-
tributes itself in the engine and screw the spark
plug back in.
5. Remove all dirt, deposits and dust from the engine
and the cylinder head ridges.
6. Clean the air filter or replace it if it is very dirty.
7. Disconnecting the battery
8. Store the power generator securely in a dry place
that is inaccessible to children.
9. The unit may not be stored in the open.
10. Cover the unit and the engine to protect against
dust and store in a clean, dry place.
When re-commissioning after a long period of
storage
1. Change the engine oil.
2. Fill with fresh petrol before starting the motor after
the storage period.
If the engine is not used for more than one month,
changes to the petrol quality may result in difficulties
starting the engine or in other issues. To prevent this,
loosen the carburettor's drain screw and allow the
petrol to run out. Also open the fuel valve so that the
petrol drains from the tank.

13. Maintenance

Attention!
Always shut the engine down and remove the spark
plug connector before carrying out any maintenance
work.
Changing the oil (fig. 8)
Change the engine oil after 25 operating hours, then
after 50 hours or every three months.
26 | GB
Drain the engine oil when the engine is hot.
1. Warm the engine up.
2. Switch the engine off.
3. Place a container that is large enough to collect
the used oil under the oil drain screw (13).
4. To drain the oil, remove the screw-on oil cap (14)
and the oil drain screw (13).
5. Drain the oil
6. Re-attach the oil drain screw (13) with a sealing
washer and tighten.
7. Pour the recommended engine oil into the oil filler
hole.
Note! Tightly screw the oil filler cap with dipstick (14).
Capacity: approximately 1.1 litres
Dispose of the drained oil properly at a local used oil
collection point. Dumping used oil in the soil or mixing
it with waste is prohibited.
Check the spark plug (fig. 10)
Switch off the engine and allow it to cool.
Caution! Danger of burning
Clean or replace spark plug as required:
1. Remove the spark plug connector (d) and clean
any dirt from the spark plug area.
2. Unscrew the spark plug and check it.
3. If there is any damage, e.g. cracks or chips, re-
place the spark plug.
4. Clean the spark plug electrodes with a wire brush.
5. Check and set the electrode gap.
6. Screw the spark plug in and tighten with the spark
plug spanner.
7. Place the spark plug connector (d) on the spark
plug.
When replacing, ensure that no dirt gets into the
cylinder head.
Check the fit of the spark plug. A loose spark plug can
cause damage to the engine by overheating.
Pulling too hard can damage the thread in the cylinder
head.
The manufacturer is not responsible for the resulting
damages; the user solely bears the risk. Only use the
recommended spark plugs or identical spark plugs.
www.scheppach.com