Cleaning; Transport; Storage - Scheppach SG7100x Original Bedienungsanleitung

When the engine is warm:
Move the choke lever (6) to the OPEN position by
moving the lever to the right.
1. Set the on/off switch (5) to the ON position
with recoil starter
2. Pull the recoil starter (9) slowly until resistance
is noticeable. Then pull firmly, repeat until the
generator has started.
with electric-start
2. Set the on/off switch (5) to the Start position and
hold until the generator has started.
WARNING: Ensure that you do not injure your fingers.
If the motor does not start and a piston was not raised
completely, the starter grip may suddenly spring back
to the engine. Avoid the starter grip springing back
against the engine. Feed it back slowly by hand to
ensure that the cover is not damaged.
Shutting the engine off
1. Switch the generator off
2. Set the engine switch to off
3. Turn the fuel valve to off
In an emergency, set the engine switch to off!
Electrical devices that can be connected
This power unit can power light bulbs, heaters,
drills, water pumps, etc. Do not exceed the load limit
specified for the power unit.
The power unit may not be used to power devices that
have a high power requirement.
The power unit cannot be used for precision devices
such as computers. These precision devices may be
damaged under certain circumstances by distortions
caused by the broad wave when the power unit's
power is output. Do not connect the power unit to the
electrical installation of a building.
WARNING: Connection to the electrical installation
of a building may result in the electric current being
returned to the mains supply wires. This return causes
a risk of a fatal electric shock for employees of the
electricity supplier or other persons who touch the
wires during a power failure.
Connection to the electrical installation of a building
can also cause the electric current of the electricity
supplier to return to the power unit. When the mains
supply is restored, the power unit may explode, burn
or cause a fire to break out in the electrical installation
of the building.
Disconnector (3)
The circuit breaker automatically disconnects the
power unit in the event of a short circuit or significant
overload of the generator at the socket. If the fuse has
automatically popped out to the off position, check that
the connected electrical appliance is in good working
order and does not exceed the circuit's permissible
load limit before pushing the fuse back in.

10. Cleaning

Attention!
Always shut the engine down and remove the spark
plug connector before carrying out any cleaning work.
We recommend that you clean the device directly after
every use.
Clean the device at regular intervals using a damp
cloth and a little soft soap. Do not use any cleaning
products or solvents; they could attack the plastic parts
of the device. Make sure that no water can penetrate
the device interior.

11. Transport

Transport
1. Allow the engine to cool before transporting.
2. Before transporting the power unit, switch the
engine switch (5) to the OFF position and turn
the fuel valve (7) to the OFF position
3. Keep the power unit level so that no petrol is
spilled. Petrol vapour or spilled petrol may ignite.
4. Ensure that the power unit does not fall and do not
subject it to any blows during transport.
5. For short transport, transport the generator using the
transport wheels (19) and the transport handle (10).

12. Storage

Store the device and its accessories in a dark, dry and
frost-free place that is inaccessible to children. The
optimum storage temperature lies between 5 and 30
˚C. Store the power tool in its original packaging. Cover
the power tool to protect it from dust or moisture. Store
the operating manual with the power tool.
When storing for a long period of time
1. Empty the fuel tank and run the carburettor empty.
2. Unscrew the spark plug.
3. Approx. Pour approximately 20 ml of clean engine
oil through the spark plug hole into the cylinder.
www.scheppach.com GB | 25