Kärcher SE 4002 Bedienungsanleitung Seite 15

 Attach the floor nozzle to the spray/suc-
tion pipes and secure with locking lever.
The appliance is now prepared for wet
cleaning.
Operations
Always work with an inserted foam
filter - during wet as well as dry vac-
uum cleaning!
Wet cleaning of carpets/hard sur-
faces/upholstery
Health risk, risk of damage!
Check the object to be cleaned prior to us-
ing the appliance in an inconspicuous place
for colour fastness and water resistance.
Do not clean water-sensitive floor cover-
ings such as wood floors (the moisture
could penetrate and damage the floor).
Note
Warm water (max. 50°C) will increase the
cleaning effect.
Wet cleaning of carpeted floors
 Use the wash floor nozzle.
 Work without the hard surface insert.
Please only use the carpet cleaner RM 519.
Wet cleaning of hard surfaces
 Use the wash floor nozzle.
 Slide the attachment for hard surfaces
onto the spray ex floor nozzle from the
side. The bristles should point towards
the back.
Wet cleaning of upholstery
 Use the wash hand nozzle.
Fill up fresh water reservoir
Note: You can remove the water reservoir
to fill it or you can fill it directly on the appli-
ance.
Illustration
 Flip the reservoir cover up.
 Add 100 - 200 ml (volume depends on
degree of contamination) of RM 519
into the fresh water reservoir, then add
tap water - do not overfill.
 Close the reservoir cover.
Start working
Illustration
 Insert the mains plug into the socket.
 Press the switch for suction (position I),
suction turbine is running.
Illustration
 Close fully the surrounding air separa-
tor at the handle.
Illustration
 Press the switch for spraying (position
I), the detergent pump is ready.
Illustration
 Use the lever on the spray handle to
spray on detergent solution.
Illustration
 For continuous spray, the spray lever
can be locked; for this, activate the
spray lever and pull the locking key to-
ward the rear.
 Run across the surface to be cleaned in
overlapping paths. Pull the nozzle back-
wards (do not push).
Emptying the reservoir during opera-
tion
Note: If the reservoir is full, a float closes
the suction opening, and the appliance
works at a higher speed.
 Switch the appliance off by pressing the
switch for suction and spraying
(position 0).
 Separate the spray/suction hose and
the spray hose from the appliance.
– 4
EN 15