Description Of The Appliance; Before Startup - Kärcher SE 4002 Bedienungsanleitung

Start up

Description of the Appliance

When you unpack the system, check that
everything is complete.
If there are any missing parts or you detect
any transport damage when unpacking,
please inform your dealer immediately.
Note: The front cover pages include pic-
tures of the appliance and its operation.
Please unfold these first.
Illustration
1 Motor casing
2 Carrying handle
3 Foam filter
4 Filter lock
5 Power cord with plug
6 Storage, power cord
7 Switch for suction (0 / I)
8 Switch for spraying (0 / I)
9 Release, fresh water reservoir
10 Fresh water tank
11 Container
12 Swivel casters
13 Connection for suction hose of the wet/
dry vacuum cleaner
14 Connection, spray hose
15 Spray/suction hose
16 Handle
17 Surrounding air separator
18 Spray lever
19 Lock key for spray mist
20 Lock lever
21 Spray / suction tubes 2 x 0.5 m
22 Storage for suction tubes and accesso-
ries
23 Wash nozzle for carpet cleaning, with
hard surface attachment
24 Wash hand nozzle for upholstery clean-
ing
14
Attachment for wet/dry vacuuming
25 Attachment for wet/dry vacuuming
26 Floor nozzle with hard surface insert
27 Crevice nozzle
28 Upholstery nozzle
29 Filter bag

Before Startup

Illustration
 Remove the fresh water reservoir.
Press the release and remove the tank.
Note: The motor casing can only be re-
moved if the fresh water reservoir was
removed first.
Illustration
 Remove the motor casing. For this,
fold the carrying handle forward to un-
latch the reservoir. Remove the acces-
sories and swivel casters from the
reservoir.
Illustration
 Turn the container, press in the swivel
casters in the openings at the base of
the container till the end-point.
Illustration
 Turn the motor casing around and at-
tach the foam filter to the filter basket.
 Insert the filter cover and turn to lock.
 Install the motor casing. Pull up on
the carrying handle to lock.
Illustration
 Install the fresh water reservoir. In-
sert the bottom part first and then press
toward the top on the motor compart-
ment to check if it is locked in.
Illustration
 Attach the suction hose and the spray
hose to the connectors on the appli-
ance.
Note: Press the suction hose tightly into
the connector to lock it into place.
Illustration
 Connect the spray/suction pipes and at-
tach to the handle. Center the locking
lever when attaching it, turn clockwise
to lock.
– 3
EN