Position Of The Decimal Point; Counting Direction (See Chapter 4); Reset Delay; Trouble Shooting - Siko MA508 Montageanleitung

MA508
34

Trouble shooting

7.3 Position of the decimal point

Description
no decimal point
1 Decimal place: "0.0"
2 Decimal place: "0.00"
3 Decimal place: "0.000"
The position of the decimal place is only used for being indicated on the
display and is not considered for the calculation.

7.4 Counting direction (see chapter 4)

Description
Positive counting
Negative counting

7.5 Reset Delay

Description
The reset function of the MA508 is triggered after
short actuating of the
The reset function of the MA508 is triggered after
longer actuating of the
8 Trouble shooting
Error description
"ERROR" display cannot be
deleted.
Displayed value does nor
correspond to the position
after calibration of the sys-
tem and traveling of the
sensor.
The battery symbol appears
after switching on the LC
display.
MA508 · Date 23.05.2017 · Art. No. 83093 · Mod. status 304/16
key (<1 sec.).
key (>2 sec.).
Possible causes / action
Distance or angle between active sensor
surface and magnetic strip is outside the
mounting tolerances.
Control resolution parameter and check
whether it is usable for the application.
Optimize distance or angle between sensor
surface and magnetic strip.
Send device to SIKO for battery replace-
ment.
English
Menu text PTM
"dP. 0"
"dP. 1"
"dP. 2"
"dP. 3"
Menu text PTM
"Zr.uP"
"Zr.dn"
Menu text PTM
"rd.no"
"rd.On"