Incremental Measurement; Input Offset Value; Error - Siko MA508 Montageanleitung

MA508
Operation and operational modes

5.2 Incremental measurement

Pressing the
NOTICE
will also result in a change to the "Absolute measurement", the display
will be recalibrated the same time, however.
Change to the operation mode "incremental measurement":
By shortly pressing the
Return to the operation mode "absolute measurement":
Renewed pressing of the
over.

5.3 Input offset value

Entering the operation mode "Offset input":
By pressing the
Programming the offset value:
Change of the value by pressing the
ing the keys shortly, the value will be changed by one increment only, if
pressed for a longer time (fast mode) the digits are incremented or decre-
mented in the fast mode.
Taking over the programmed offset value:
Renewed pressing the
operating mode changes to "absolute measurement" again. After pro-
gramming display parameters (see chapter 6) or after "Power On" (battery
replacement) the offset value = 0.

5.4 ERROR

As soon as the "ERROR" status occurs, position changes will no longer be
NOTICE
sensed.
The MA508 is set to the "ERROR" no matter whether the display is
switched on or off. When the display is switched on, the "ERROR" status is
signalled on the display by a text of the same name.
Possible causes for the ERROR status:
1. The distance between the magnetic strip and the sensor's scanning
MA508 · Date 23.05.2017 · Art. No. 83093 · Mod. status 304/16
key in the operating mode "Incremental measurement"
key for a longer time.
surface is outside the mounting tolerance.
key, the value "0" will now be displayed.
key. Changes of the position value are taken
(+) and
key. The changed value is taken over and the
English
(-) keys. By press-
29