Electrical Installation - Siko MA508 Montageanleitung

MA508
Installation
Loss of measured values
NOTICE
` Observe the specified tolerances and distances over the whole mea-
3. Mount the magnetic tape (see chapter 4.3).
4. Mount the electronic display with integrated magnetic sensor (see
Fig. 8: Definition of the counting direction with magnetic tape and
with integrated sensor / magnetic tape, gap measure, tolerances

4.6 Electrical installation

On principle, all connections are protected from external parasitic induc-
NOTICE
tion. Choose a place of installation that protects the display or its con-
nection lines from the effects of inductive, capacitive and/or magnetic
disturbances. When mounting the system keep a maximum possible dis-
tance from lines loaded with interference. If necessary, provide additional
installations including screening shields or metallized housings.
With sensor cable lengths >0.3 m the display's housing and the PE-con-
NOTICE
nection near the sensor (see
The customer needn't provide a service line since the device is operated
mains-independent via an integrated lithium battery and the sensor is
hard-wired to the display.
MA508 · Date 23.05.2017 · Art. No. 83093 · Mod. status 304/16
suring length.
chapter 4.2).
3
1
2
1
2
3
Fig. 7) must be properly earthed!
English
Active side of the mag-
netic tape
Admissible deviation of
tape/sensor
0.1 ... 1.5 mm
Travel direction: positive
counting direction
27