Symbols On The Battery - Husqvarna AUTOMOWER 305 Bedienungsanweisung

In the settings menu you can set the
general settings of the product.
In the accessories menu you can set the
settings for the accessories of the product.
The schedule is set for the product to not
cut the grass.
The product overrides the schedule.
The battery indicator shows the charge
level of the battery. When the product
charges the symbol flashes.
The product is in the charging station but
do not charge the battery.
The product is set in ECO-mode.
®
Bluetooth wireless communication with
your mobile device.
The GPS-supported navigation is active.
Flashes as it collects GPS information.
The GPS-supported navigation is not
active.
The signal strength of the GPRS
reception.
Problem with the connection to the
Internet server.
6 - Introduction
Problem with the SIM card or the module.

1.7 Symbols on the battery

Read the user instructions.
Do not discard the battery into fire and do
not expose the battery to a heat source.
Do not immerse the battery into water.
1.8 General manual instructions
The following system is used in the Operator's Manual
to make it easier to use:
• Text written in italics is a text that is shown in the
display or is a reference to another section in the
Operator's Manual.
• Text written in bold is one of the buttons on the
product.
1.9 Display
The display on the product shows information and
settings of the product.
To access the display, push the STOP button.
1.10 Keypad
Use the keypad on the product to move around in the
menu structure. To get access to the keypad, push the
STOP button.
• Use the ON/OFF button (A) to set the product
to ON or OFF. The LED indicator on the keypad
shows if the product is ON or OFF. Refer to
the ON/OFF button on page 16 .
• Use the START button (B) to start the operation of
the product.
• Use the BACK button (C) to move up in the menu
lists.
• Use the arrow buttons (D) to move around in the
menu.
• Use the OK button (E) to do selections.
• Use the MENU button (F) to go to the main menu.
• Use the PARK button (G) to send the product to
the charging station.
To use
1508 - 011 -