Husqvarna AUTOMOWER 305 Bedienungsanweisung Seite 18

4.3.1.2 Start again with next schedule
Start again with next schedule
Use the operating mode
for the product to go back to the charging station. The
product will stay in the charging station until the next
Schedule setting.
4.4 To stop the product
1. Push the STOP button to make the product and
the cutting motor stop.
4.5 To set the product to OFF
1. Push the STOP button to open the hatch.
2. Push the ON/OFF button for 3 seconds.
3. Make sure that the LED indicator on the keypad is
off to make sure that the product is set to OFF.
4.6 To charge the battery
WARNING:
using a charging station which is intended
for it. Incorrect use may result in electric
shock, overheating or leakage of corrosive
liquid from the battery.
In the event of leakage of electrolyte flush
with water and seek medical help if it comes
in contact with the eyes etc.
When the product is new or has been stored for a long
period, the battery can be empty and must be charged
before you can start the product. In the
the product cuts and charges automatically.
1. Push the ON/OFF for 3 seconds button to start the
product.
2. Put the product in as far as possible in the
charging station.
3. Make sure that the charging plates on the charging
station connects to the contact plates on the
product.
18 - Operation
Only charge the product
Main area mode,
4. Do a check that the display shows the message
CHARGING to make sure that the product is
connected correctly to the charging station.
4.7 Adjust the cutting height
CAUTION:
During the first weeks after
a new installation, the cutting height must be
set to MAX to avoid damaging the loop wire.
After this, the cutting height can be lowered
step by step every week until the desired
cutting height has been reached.
The cutting height can be varied from MIN (2 cm / 0.8
in.) to MAX (5 cm / 2 in.).
4.7.1 To adjust the cutting height
®
(Automower 305 / 310 Mark II / 315 Mark
II)
1. Push the STOP button to stop the product.
2. Open the hatch.
3. Turn the cutting height adjustment knob to select a
cutting height.
a) Turn clockwise to increase the cutting height.
b) Turn counterclockwise to decrease the
cutting height.
4.7.2 To set the cutting height (Automower
405X / 415X)
To get access to the menu in the
1. Do steps 1–3 in
display of the product on page 15 .
2. Use the arrow buttons and the OK button to
move through the menu structure
Cutting height .
3. Use the arrow buttons to set the cutting height.
4. Push the OK button.
®
Cutting height >
1508 - 011 -