Troubleshooting - Husqvarna AUTOMOWER 305 Bedienungsanweisung

on a regular basis for the best mowing result and
low energy usage. All 3 blades and screws must be
replaced at the same time to obtain a balanced cutting
system. Use Husqvarna original blades embossed with
the crowned H-mark logotype, refer to
on page 26 .

6.1 Troubleshooting

In case of malfunction, a message will appear on the display. For more detailed information on messages, refer to the
complete Operator's manual on Husqvarna's website (www.husqvarna.com). If the same message appears often or if
you still cannot find the reason for the fault, contact your local Husqvarna representative.
Breaks in the loop wire are usually the result of unintentional physical damage to the wire such as when gardening
with a shovel. Breaks can also be due to the wire being stretched excessively during installation. A wire break can be
located by gradually halving the distance of the loop where the break may have occurred, until there is only a very
short section of the wire left. Refer to the complete Operator's manual on Husqvarna's website (www.husqvarna.com).
6.1.1 LED indicator of the charging station
The LED indicator of the charging station is green when
the installation is correct. If the LED indicator of the
charging station is not green, follow the troubleshooting
table below.
LED indicator Cause
Constant green The signals of the charging station are good.
Flashes green The signals of the charging station are good
and
Flashes blue The boundary wire is not connected to the
charging station.
The boundary wire is damaged.
Flashes red Interference in the antenna of the charging
station.
Constant red Error in the circuit board or incorrect power
supply in the charging station.
20 - Troubleshooting
Warranty terms
6 Troubleshooting
ECO mode is enabled.
5.4.1 To replace the blades
1. Switch off the product with the ON/OFF button.
2. Put the product upside down on a clean and soft
surface.
3. Rotate the skid plate until the holes align with the
screws for the blade.
4. Remove the 3 screws.
5. Remove the 3 blades and the screw.
6. Attach 3 new blades and screws. Use Husqvarna
original blades.
7. Make sure that the blades can move freely.
Speak to your local Husqvarna representative or go to
www.husqvarna.com for more information.
Action
No procedure is necessary.
No procedure is necessary.
Connect the boundary wire to the charging
station.
Replace the damaged section of the boun-
dary wire with new boundary wire.
Speak to your local Husqvarna representa-
tive.
The error must be corrected by an authorized
service technician. Speak to your local Husq-
varna representative.
1508 - 011 -