Menu Structure; To Get Access To The Menu In The Display Of The Product - Husqvarna AUTOMOWER 305 Bedienungsanweisung

2. If the indicator LED lamp does not have a green
light, do a check of the installation. Refer to
indicator of the charging station on page 20 and
To install the charging station on page 12 .
3.6 To do the basic settings
Before the product starts to operate for the first time, you
must do the basic settings.
1. Put the product in the charging station.
2. Switch on the product.
3. Push the arrow buttons and the OK button. Select
language, country, date, time and set a PIN code.
Note:
For some models, a factory PIN code is
necessary before you select a personal PIN code.
It is not possible to use 0000 as PIN code.
4. Push the Start button and close the hatch to initiate
a calibration process of the product.
Note:
Make a note of the PIN code. Refer to
Introduction on page 2 .

3.7 Menu structure

3.7.1 To get access to the menu in the
display of the product
1. Push the STOP button.
2. Use the number buttons and the OK button to
enter the PIN code.
3. Push the MENU button.
3.7.2 Submenus
There are a number of submenus under each option.
You can access all the functions to set the product
settings via the submenus.
Certain submenus contain options that are ticked off to
the left. This means that these options are selected.
Check or uncheck the box by pushing the OK button.
3.7.3 Main menu
Schedule
The Schedule function controls which
hours the product must operate. Set the
schedule if the work area is less than
the maximum area capacity of the product
to prevent wear on the grass and the
product.
Cutting height (Automower
Cutting height can be adjusted in 9
The
steps. Use the
lower the cutting height automatically from
1508 - 011 -
LED
®
405X / 415X)
TargetHeight function to
maximum to the specified cutting height
gradually during 10 days.
Security
Security menu you can set the
In the
security level and the security settings of
the product.
Messages
Messages menu you can find the
In the
Fault messages and Info messages of the
product. You can also find information and
solutions to correct the fault.
Weather timer
Weather timer function automatically
The
adapts the cutting intervals to the grass
growth.
Installation
You can use the factory setting for
the installation of the product for most
work areas. If it is necessary to change
the installation settings for your work
area, you can set the manual installation
Installation menu.
settings in the
Settings
Settings menu you can enable and
In the
disable functions such as
Spiral cutting and set the time and date
of the product. Husqvarna recommends to
ECO mode function to save
enable the
energy and to prevent interference with
other equipment.
Accessories
Accessories menu you can set the
In the
settings for the accessories of the product,
for example the settings for Automower
Connect. Speak to your local Husqvarna
representative for information about which
accessories that are available for your
product.
®
3.8 Automower Connect app
The product can connect to mobile devices that have
®
the Automower Connect app installed. Automower
Connect is a free app for your mobile device. You
can use the extended functions for the product in the
®
Automower Connect app.
ECO mode ,
®
®
Installation - 15