Installation Tools - Husqvarna AUTOMOWER 305 Bedienungsanweisung

Make the eyelet with approximately 20 cm / 8 in. of the
boundary wire.
• Make a blueprint of the work area before you install
the boundary wire and guide wire.
E
C
A
• Put the boundary wire around the work area (A).
Adapt the distance between the boundary wire and
obstacles.
a) Put the boundary wire 35 cm / 14 in. (B) from
an obstacle that is more than 5 cm / 12 in.
high.
b) Put the boundary wire 30 cm / 12 in. (C) from
an obstacle that is 1-5 cm / 0.4-2 in. high.
c) Put the boundary wire 10 cm / 4 in. (D) from
an obstacle that is less than 1 cm / 0.4 in.
high.
• If you have a paving stone path that is in level with
the lawn, put the boundary wire below the paving
stone.
Note:
If the paving stone is minimum 30 cm / 12
in. wide, use the factory setting for the
Wire function to cut all the grass adjacent to the
paving stone.
• If you make an island, put the boundary wire that
goes to and from the island near together (E). Put
the wires in the same stake.
• Make an eyelet (F) where the guide wire is to be
connected to the boundary wire.
Read the full Operator's manual for more information.
You can get information about how to install the
boundary wire in slopes and in narrow passages. Also
about how to make secondary areas in which you move
the product manually to the selected work area.
12 - Installation
3.4.4 To examine where to put the guide
wire
•
•
D
F
•
•
•
3.5 Installation of the product
B

3.5.1 Installation tools

•
•
•
•
3.5.2 To install the charging station
Drive Past
Put the guide wire in a line at a minimum of 2 m /
6.5 ft. in front of the charging station.
Make as much free area as possible to the left of
the guide wire when facing the charging station.
Put the guide wire minimum 30 cm / 12 in. from the
boundary wire.
Do not make sharp bends when you install the
guide wire.
135º
135º
If the work area has a slope, put the guide wire
diagonally across the slope.
Hammer/plastic mallet: To simplify putting the
stakes into the ground.
Edge cutter/straight spade: To bury the boundary
wire.
Combination pliers: For cutting the boundary wire
and pressing the connectors together.
Adjustable plier: For pressing the couplers
together.
WARNING:
Obey national regulations
about electrical safety.
WARNING:
The product is only to be
used with the power supply unit supplied by
Husqvarna.
WARNING:
Do not put the power
supply at a height where there is a risk it can
be put in water. Do not put the power supply
on the ground.
WARNING:
Do not encapsulate the
power supply. Condensed water can harm
the power supply and increase the risk of
electrical shock.
90º
1508 - 011 -