Automatic Reduction In Performance; Operating Time Limit; Automatic Safety Switch-Off; Locking Function (Child Safety Function) - hanseatic HHI64BAF Gebrauchsanleitung

Automatic reduction in
performance
The temperature of the electronic elements
inside the hob are constantly measured using
a sensor. If the heat increases too rapidly, the
heating level in the cooking zone where the
electronic elements are likely to overheat will
automatically reduce or the elements in the
adjacent cooking zone to the one where the
elements are overheating will be automatical-
ly switched off. In an extreme case, the hob
will be completely switched off automatically.
Once the electronic elements have once
again cooled sufficiently, the heating level will
once again be restored to the original setting.

Operating time limit

For your safety, all of the cooking zones are
equipped with an operating time limiter. If
the heating level hasn't been changed for a
longer period of time (see the following table),
the cooking zone switches off automatically
and the residual heat indicator is activated.
The maximum operating time is set in accord-
ance with the most recently selected heat set-
ting.
Maximum heating
Heat setting
1, 2, 3
4, 5, 6
7, 8, 9

Automatic safety switch-off

If excessively high temperatures are reg-
istered inside the hob housing, the hob will
switch off automatically for security reasons.
Using and caring for the hob
Locking function (child safety
function)
The locking function is intended to prevent
the following situations:
– unauthorised or unintentional changes be-
– unauthorised or unintentional switching off
To
• activate the function, touch the safety lock
• deactivate the function, touch the safety
are locked
off the hob at any time using the On/Off sen-
sor
If the hob has been switched off while the
safety lock was activated, the hob cannot be
switched on again until the safety lock has
been deactivated.
duration
Using the appliance as a
8 hours
kitchen timer
4 hours
2 hours You can use the appliance's timer function as
a kitchen timer. In this case, set the time with-
out selecting a cooking zone.
– The hob and at least one cooking zone
– The cooking zone must not flash any
ing made to the settings of the active cook-
ing zones;
of the hob.
sensor (6) for a few seconds.
The " " indicator will flash.
Lo
lock sensor for a few seconds again.
The " " indicator will go out.
Lo
If the safety lock is switched on, all
sensors apart from the On/Off sensor
(7). If required, you can switch
.
must be switched on.
longer.
Page EN-17