hanseatic HHI64BAF Gebrauchsanleitung Seite 54

Cooking time limit for one cooking
zone
Requirement: The hob is switched on.
6
1. Touch the cooking zone sensor (9) of the
cooking zone for which you want to set
the cooking time limit.
The indicator will flash.
2. Set the desired heat level.
0
3. Touch the timer sensor
cooking zone indicator is still flashing.
4. Set the required time by touching the set-
ting sensor / (8).
6 3
6
The timer indicator (11) will flash and show
the set time.
After 5 seconds, the timer indicator will be
constantly illuminated and will count the set
time down.
Using and caring for the hob
5. To switch off the cooking time limit in the
(10) while the
6. Touch the timer sensor
1 minute. Touching and holding the setting
sensors
by 10 minutes.
out all of the steps once again.
The flashing red dot next to the cooking
zone indicator shows that the cooking time
limit is activated for this cooking zone.
− −
Once the pre-set time has elapsed, the
cooking zone will switch off automatically
and the residual heat indicator "
up.
6
interim, touch the cooking zone sensor of
the active cooking zone.
The indicator for that cooking zone will
flash.
both setting sensors and .
The timer indicator will show "
Each touch of the setting sensors
/ reduces or increases the time by
/ reduces or increases the time
If you would like to amend the set time
in the interim, you will need to carry
Page EN-19
" will light
H
0 0
and then touch
".
00