Troubleshooting - BWT AQA Smart Einbau- Und Bedienungsanleitung

T T T T T roub roub roub leshooting leshooting
roub roubleshooting leshooting leshooting
GB GB GB GB
GB
Fault Fault Fault
Fault Fault
S A L t S A L t S A L t is indicated on the
S A L t S A L t
display.
Unit not supplying softened or
blended water.
Unit not supplying softened
water or the flow is insufficient.
Coloured flushing water at
start-up.
If the fault cannot be remedied by following these steps, contact our after-sales service If the fault cannot be remedied by following these steps, contact our after-sales service If the fault cannot be remedied by following these steps, contact our after-sales service If the fault cannot be remedied by following these steps, contact our after-sales service If the fault cannot be remedied by following these steps, contact our after-sales service
department and quote the series and production number (see type plate). department and quote the series and production number (see type plate). department and quote the series and production number (see type plate).
department and quote the series and production number (see type plate). department and quote the series and production number (see type plate).
42 42 42 42 42
Cause Cause Cause
Cause Cause
Insufficient regenerative in the
storage area (5 5 5 5 5 ).
Insufficient pipeline pressure
resulting in insufficient suction
speed.
No regenerative in the storage
area (5 5 5 5 5 ).
Power supply interrupted.
Blending adjusting spindle (V V V V V )
not set correctly.
Inlet pressure is too low.
Abrasion particles
exchanger resin.
Remedy Remedy Remedy
Remedy Remedy
Refill regenerative and press
OK OK
the OK OK OK button until the SALt
display goes out.
Press the OK OK OK OK button to ac- OK
knowledge the fault.
If the fault occurs again, con-
tact after-sales service.
Refill regenerative, then press
OK OK
the OK OK OK button until the SALt
indicator goes out. Wait 3 hours
for the brine to form and start
manual regeneration.
Establish electrical connection.
Set as described in the Start-
up section „Setting the hard-
ness of blended water".
Increase inlet pressure (set
pressure reducer if neces-
sary) and start manual regen-
eration.
from Repeat start-up flush.
SALt SALt
SALt SALt
SALt SALt
SALt SALt