BWT AQA Smart Einbau- Und Bedienungsanleitung Seite 30

GB GB GB GB
GB
30 30 30 30 30
9 9 9 9 9
10 10 10 10 10
> 20 mm > 20 mm > 20 mm > 20 mm > 20 mm
Attach the grey cover to the left side of the control
valve.
Firmly insert the flushing water hose into the flush-
ing water connection elbow (9 9 9 9 9 ).
Route the flushing water hose at an incline to the
sewage system connection (drain) and secure the
end with the fixing material supplied to prevent it
"flapping about" when under pressure.
Attach the overflow hose (18 x 24) to the overflow
(10 10). Secure it with cable ties and route it with an 10 10 10
incline of at least 10 cm to the sewage system
connection (drain).
The flushing water and overflow hoses must not
be connected or constricted at any point.
Note: In accordance with DIN 1988, the flush- Note: In accordance with DIN 1988, the flush- Note: In accordance with DIN 1988, the flush- Note: In accordance with DIN 1988, the flush- Note: In accordance with DIN 1988, the flush-
ing water and overflow hoses must be con- ing water and overflow hoses must be con-
ing water and overflow hoses must be con- ing water and overflow hoses must be con- ing water and overflow hoses must be con-
nected to the sewage system at least 20 mm nected to the sewage system at least 20 mm nected to the sewage system at least 20 mm nected to the sewage system at least 20 mm nected to the sewage system at least 20 mm
above the highest possible waste water level above the highest possible waste water level
above the highest possible waste water level above the highest possible waste water level above the highest possible waste water level
(unimpeded drainage). (unimpeded drainage). (unimpeded drainage). (unimpeded drainage). (unimpeded drainage).