Set Up And Transport Of The Unit - Dantherm CDT 30S Handbuch

Set up and transport of the unit

Introduction This section provides information required for:
 unwrapping the unit
 making it ready for use
 transportation of the unit
WARNING If the dehumidifier has been laid down during transport, it is imperative that you
place it in upright position for at least 1 hour before put into service!
Procedure
Follow these steps to unwrap the unit and make it ready for use:
Placing Place the dehumidifier:
 in the middle of a room if possible to ensure
 where air can be sucked in freely at the back
 with a minimum distance on the supply air
 away from any source of heat e.g. a radiator
In addition, ensure that windows and doors to the open are closed in the room to be
dehumidified.
56
Step Action
1 Open the cardboard box in the top
2 Place the box with the handle and
wheels on the floor
3 Pull the handle and wheel the dehu-
midifier out while lying down
4 Loosen the finger screws and pull
the handle up and tighten the finger
screws
good air circulation
of the unit and blown out at the front
side from a wall of about 60 cm (see drawing).
The minimum distance on the exhaust air side
should be 3 m unless exhaust air hoses are
connected
Illustration
Continued overleaf