Error Messages - Sentiotec O-CV41 Montage- Und Gebrauchsanweisung

Instructions for use for the user
4. Insert tabs
3
carefully press onto the housing lower part
5. Place the housing cover
and press until it clicks audibly. Check the fit of the control unit.

9.4. Error messages

An error message indicates an electrical malfunction in the system.
The sauna control unit is no longer operational.
Error Description
Error 1 Overheat cut-out FI
defective
Error 3 Break in sensor line FI
Error 4 Short-circuit FI
Error 5 Short-circuit F2
Error 6 Line interruption F2
of the operating unit
onto the housing lower part
6
into the two lateral holders
2
to the stop position.
7
Cause / Remedy
See point "6. Performing tests" on
page 16
See point "6. Performing tests" on
page 16
Check the sensor lines and the terminals
Check the sensor lines and the terminals
Check the sensor lines and the terminals
p. 29/34
and
4
, swivel downward
7
EN