Electrical Safety; Residual Risks - Parkside PUB 500 B1 Originalbetriebsanleitung

vice or bolts are missing, worn
out or damaged.

Electrical safety:

CAUTION! The following states
how to avoid accidents and
injuries due to electric shock:
• Never cross the extension cable
while the device is operating.
Always keep the extension ca-
ble behind the device operator.
Should the power cable be-
come damaged during work,
then instantly disconnect the
power cable from the mains.
DO NOT TOUCH THE POWER
CABLE BEFORE IT HAS BEEN
DISCONNECTED FROM THE
MAINS! Risk of electric shock.
• Before each usage, check the
mains power cable and the
extension cable for damage
and signs of aging. Do not use
the device if the cable is dam-
aged or worn. Damaged mains
power cables increase the risk
of electric shock.
• If the power cable for this
equipment is damaged, it must
be replaced by the manufac-
turer, a customer service agent
of the same or a similarly quali-
fi ed person in order to prevent
hazards.
• Check that the mains voltage
is the same as indicated on the
rating plate.
• Connect the equipment to a
power socked with a residual-
current circuit breaker that has
a rated current of not more than
30 mA.
GB
• Protect the equipment from
moisture. The equipment must
not be moist nor operated in a
moist environment. Water entry
into the equipment increases the
risk of electric shock.
• Avoid body contact with
earthed parts (e.g. metal
fences, metal posts). There is an
increased risk of electric shock
if your body is earthed.
• Only use extension cables with
a maximum length of 75 m that
have been approved for open-
air use. The stranded cord diam-
eter of the extension cable must
be at least 2.5 mm
unreel a cable drum to its full
length so that the entire cable
can be inspected for damage.
• Use the envisaged cable sus-
pensions when attaching an
extension cable.
• Never carry the equipment by
its power cable. Never pull the
cable to disconnect the plug
from the mains socket. Protect
the cable from heat, oil and
sharp edges. The mains power
cable could be damaged.
Service
• Have your power tool ser-
viced by a qualifi ed repair
person using only identi-
cal replacement parts. This
will ensure that the safety of the
power tool is maintained.

Residual risks

Even if properly operating and han-
dling this electric tool, some residual
IE NI CY
. Always
2
9