Assembly Instructions; Assembling The Motor Head; Inserting/Replacing The Brush; Mounting The Guiding Roller - Parkside PUB 500 B1 Originalbetriebsanleitung

GB IE
NI
risks will remain. Due to its construc-
tion and build, this electric tool may
present the following hazards:
a) Eye damage if working without
eye protection.
b) Ear damage if working without
ear protection.
c) Damage to your health caused
by swinging your hands and
arms when operating the appli-
ance for longer periods of time
or if the unit is not held or main-
tained properly.
Warning! During operation,
this electric tool generates an
electromagnetic fi eld which,
under certain circumstances,
may impair the functionality
of active or passive medical
implants. To reduce the risk of
serious or lethal injuries, we
recommend that persons with
medical implants consult their
doctor and the manufacturer
of their medical implant be-
fore operating the machine.
Assembly
instructions
The brush support (16), the hexa-
gon socket wrench (17), the metal
brush (18) and the nylon brush (19)
are situated in the two compart-
ments in the additional handle (14).
Assembling the motor
head
1. Place the telescopic arm (
the motor head (12).
2. Tighten the screw sleeve, motor head (
10
CY
8) onto
13) by hand onto the threaded ele-
ment of the motor head (12).

Inserting/replacing the brush

Plastic brush (10):
1
Release/fasten the fi xing screw on the inside
of the plastic brush (10) on the motor head
(12) using the hexagon socket wrench (16).
Metal brush (18)/
2
nylon brush (19):
1. Push open the brush support (16) and at-
tach it as it is to the motor head (12) (see
A ).
2. Insert the desired brush (18/19).
3. Release the brush support (16) and it will
spring back into its initial position.
4. To remove the brush, push the brush
support (16) open and remove the brush
(18/19) (see B ).
Mounting the guiding
3
roller
1. Insert the guiding roller (11) on to the mo-
tor head (12). It locks into place audibly.
- If using the plastic brush (10), place
the guiding roller (11) into the trans-
port position (21).
- If using the metal/nylon brush
(18/19), place the guiding roller (11)
into the working position (20).
2. Release the guiding roller (11) by
pushing the retaining tab (22) and re-
move the guiding roller (11).
Mounting the additional
4
handle
1. Unscrew the additional handle (14) to
take apart.