Putting In The Containers For Oil And Uv Additive - Waeco AirConServiceCenter ASC1000 Bedienungsanleitung

AirConServiceCenter
1. In standby mode, use the cursor keys
"Other selections":
2. Press ENTER to confirm.
3. Use the cursor key
4. Press ENTER to confirm.
5. Enter the password "7388".
6. Use the keypad and the cursor keys to enter the information.
7. Press ENTER to confirm.
8. Press STOP to go to standby mode.
6.6

Putting in the containers for oil and UV additive

The current levels are shown in the info menu (chapter "Opening the info
menu" on page 72).
1. Open the cover flap (20) on the left hand side and connect the
containers to the snap locks:
– Container for new oil (17)
– Container for UV additive (18) and
– Container for used oil (19)
2. Close the cover flap (20).
3. Enter the container size for fresh oil and UV contrast agent
(chapter "Entering the container size (ASC2000, ASC2000RPA,
ASC3000 only) . . ." on page 70).
EN
Short selection
Free selection
Other selections
ENTER-OK
to select "Service".
20
First start-up
or to select
18
17
19
69