Cleaning And Maintenance - Waeco AirConServiceCenter ASC1000 Bedienungsanleitung

Service tasks
1. Undo the screws (D) on the control panel and lift it up.
2. Open the fastening of the WAECO flash memory card and pull out
the card (L).
3. Put in a new WAECO flash memory card and fasten it.
4. Lower the control panel and screw it down.
5. Close the control panel and connect in the power plug.
6. Switch on the device and follow the instructions on the display.
I
NOTE
When you switch it on again, the values should be transferred from the
flash memory card to the device. To do this, switch to "Other selections
– Service" and enter the password 1518. Acknowledge the subsequent
display messages with ENTER.
8.10

Cleaning and maintenance

 Clean the exterior of the device with a damp cloth as required.
If necessary, use a small amount of dishwashing detergent.
Do not use solvents or scouring agents.
 Regularly check the service hoses (11) and (12) and the
service couplings (13) and (14) for damage. Do not start
up the AirConServiceCenter if it is damaged.
96
D
L
AirConServiceCenter
D
EN