Entering The Date And Time; Editing Default Values - Waeco AirConServiceCenter ASC1000 Bedienungsanleitung

First start-up
9. Press STOP. The set data is activated.
10. Press STOP again to go to standby mode.
6.4

Entering the date and time

The date and the time are printed along with the company data on every
service log.
1. In standby mode, use the cursor keys
"Other selections":
2. Press ENTER to confirm.
3. Use the cursor key
4. Press ENTER to confirm.
5. Enter the password "8463".
6. Use the keypad and the cursor keys to enter the information.
7. Press ENTER to confirm.
8. Press STOP to go to standby mode.
6.5

Editing default values

The AirConServiceCenter has preset values for the most important ser-
vice tasks. The default values appear automatically when you select the
respective menu.
You can alter the following default values if necessary:
Parameter
Pressure increase Test time min.
Vacuum Time min.
Leak test min.
PAG Oil ml.
UV Tracer ml.
Filling Qt. g.
Print recovery value?
Refrigerant analysis (ASC2000RPA only)
Nitrogen Test (nur ASC2000RPA only)
68
Short selection
Free selection
Other selections
ENTER-OK
to select "Service".
AirConServiceCenter
or to select
Default value
5
20
4
10
7
500
Yes
Yes
Yes
EN