Igloo With Built-In Temperature Recorder (Mini Usb) - Igloo Variant Bedienungsanleitung

9.2. IGLOO with built-in temperature recorder (mini USB)

Check the set temperature (inside the equipment) – Press"
temperature appears on the display, accompanied by a blinking red dot (LED). The preview will automatically end after
about 3 seconds.
Increase or decrease the temperature - press
reduce the temperature to the desired value. The function will be deactivated automatically after about 3 seconds.
Manual defrosting – press button 2 to start the defrosting cycle anytime (independently of the automatic defrosting func-
tion); the button is inactive when the temperature is higher than the defrosting end temperature.
It is recommended to turn the unit on/off using only the man switch, and not the switch „
thermostat panel. Putting the main switch to ON automatically starts the thermostat!
IMPORTANT: If the main switch is ON and the display shows only two dots, it means that the thermostat
is off and should be activated
Press the button „
*More on www.igloo.pl
22
Instruction manual - cooling and freezing devices
" (or „ ") and the panel will display the set temperature. Press " " to
"on the thermostat panel.
Fig. 15 IGLOO thermostat panel
1 – Refrigeration on/off button
2 – Manual defrosting button
3 – Digital display
4 – Increase temperature button
5 – Decrease temperature button
6 – Button for preview of temperature on defro-
sting sensor. Used to change the internal control-
ler parameters
7 – Mini USB for temperature recorder
" or „ " once to check the temperature. The set
en
" on the
IGLOO.PL