6. Place the grease filters (8) with the pins
into the openings.
7. Push the locks (7) down; snap the
grease filters (8) in and release the
locks.
8. Close the cover (6) again and allow it to
click into place.
9. Switch the power back on.
10. Dispose of the used charcoal filter with
household waste.
Replacing the LED light
WARNING
Risk of injury!
Should one of the LEDs stop working,
■
it must be changed by an authorised
service technician.
Note for the service technician:
This exhaust hood requires LEDs with the
ILCOS D-Code
DSR-1.5/65-S-64 DC12 V, 2 ×1.5 W.
Care and maintenance
(6)
(7)
(8)
Page EN-11