Setting The Switch-Off Delay; Lighting; Setting The Light Level - hanseatic SY-3503C5-E15-C44-L191-600 Gebrauchsanleitung

Page GB-16 Operation

Setting the switch-off delay

Your exhaust hood is equipped with a switch-
off delay, which allows you to set the device
so that it shuts off automatically after a se-
lected time.
The switch-off delay can only be set if
the appliance is switched on.
Switch-off delay settings are not maintained
when the appliance is switched off.
1. Press the timer sensor (14)
dicator flashes on the display.
2. Touch the slider (16) on the bar that cor-
responds to the desired switch-off delay
time:
Number of Delay (minutes)
bars
1
2
3
4
5
6
7
8
The corresponding indicator flashes on
the display.
3. Press the (14) timer sensor
switch-off delay indicator lights up on the
display. The time display counts back-
wards in minutes, and in seconds where
there is a remaining time of one minute.
If the last step is not carried out, the
indicator will stop fl ashing after
approx. 5 seconds and light up. The switch-
off delay is then also set.
. The 05 in-
5
10
15
20
25
30
35
40
again. The

Lighting

The exhaust hood is equipped with an LED
light. The light turns on when the appliance is
turned on via the sensor (18)
• To switch the lighting on or off, touch the
sensor (15) .

Setting the light level

When the appliance is switched on, the light-
ing is set to the highest level. However, there
are two ways to change the lighting level.
– via the sensor (15)
1. Touch the sensor (15)
switches itself off.
2. Touch the sensor (15)
indicator flashes on the display.
3. Touch the slider (16) on the bar that cor-
responds to the desired lighting level. The
desired lighting level indicator will flash.
4. Touch the sensor (15)
lighting level indicator will light up.
This changes the lighting level.
If the last step is not carried out, the
indicator will stop fl ashing after
approx. 5 seconds and light up. The lighting
level is then also set.
– via the sensor (17)
1. Touch the sensor (17)
off; the L8 indicator will appear on the dis-
play.
2. Touch the slider (16) on the bar that cor-
responds to the desired lighting level. The
desired lighting level indicator will flash.
3. Touch the sensor (17)
lighting level indicator will light up.
4. Touch the sensor (17)
level indicator appears and the fan starts.
.
. The light
again. The L8
. The desired
. The fan shuts
. The desired
again. The fan