Setting The Brightness (Dimming Function) On The Unit; Dimming Function Niova 120 Plus Bi Color On The Unit; Dimming Function Niova 350 / 500 Plus Daylight On The Unit; Setting The Colour Temperature On The Unit (Only Niova 120 Plus Bi Color Model) - Walimex Pro NIOVA 120 Plus-Serie Gebrauchsanleitung

8.2 Setting the brightness (dimming function) on the unit

8.2.1 Dimming function Niova 120 Plus Bi Color on the unit

• Switch the unit on at the ON / OFF switch (15) (if not already done).
• Depending on the last selected functionality, the status LED of the dimmer display already
lights up in the display.
• If the <Dimmer> status LED is not lit, press the Brightness / Colour Temperature <D/C>
selection button (19), if necessary, to switch between setting the brightness and the colour
temperature (see overview above).
• The <Dimmer> status LED lights up.
• The selected luminosity is shown in the display as a percentage.
• Turn the rotary control (17) to set the desired brightness.
• The luminosity can be adjusted in 1% steps from 10 to 99 %.
• The value for the luminosity is accepted by the unit immediately after turning the knob,
stored and shown in the display.

8.2.2 Dimming function Niova 350 / 500 Plus Daylight on the unit

• Switch the unit on at the ON / OFF switch (15) (if not already done).
• The display shows the luminosity in % as last set.
• The luminosity can be adjusted in 1 % steps from 10 to 99 % by means of the rotary control
(17) in 1 .
• The value for the luminosity is immediately accepted by the unit, saved and shown in the
display.

8.3 Setting the colour temperature on the unit (only Niova 120 Plus Bi Color model)

• Switch the unit on at the ON / OFF switch (15) (if not already done).
• Depending on the last selected functionality, the status LED in the display is already illuminated.
• If the status LED is not lit, press the Brightness / Colour Temperature <D/C> selection
button (19), if necessary, to toggle between the Brightness and Colour Temperature setting
(Fig. Status Display Niovia 120 Plus on page 14).
• The status LED <Color> lights up.
• The currently set colour temperature is indicated in abbreviated form by two digits in the
display of the luminaire. Here, for example, 32 stands for 3,200 Kelvin, 44 for 4,400 Kelvin
and 56 for 5,600 Kelvin.
• Turn the rotary control (17) to set the desired colour temperature.
• The colour temperature can be adjusted in steps of 100 from 3,200 to 5,600 Kelvin.
• The value for the colour temperature is accepted by the unit immediately after turning the
knob, stored and shown in the display.

8.4 Setting the remote control channel on the unit

8.4.1 Setting the remote control channel on Niova 120 Plus Bi Color

• Switch the unit on at the ON / OFF switch (15) (if not already done).
• Depending on the last selected functionality, one of the three status LEDs lights up in the
display or the display flashes.
• When the display flashes, the unit is already in the channel selection menu.
• If this is not the case, press the channel selection button (16) to activate the channel selection
mode.
42