Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
7.3.2 Adjusting the light intensity
• Press the <ON> (2) button on the remote control to switch the light on.
• Increase the luminosity value of the fixture by pressing the <up> arrow button (4) or the
<right> arrow button (6) on the remote control.
• Decrease the luminosity value of the lamp by pressing the <down> arrow button (7) or the
<left> arrow button (5) on the remote control.
• The brightness can be adjusted in 1% steps from 10 to 100 %.
• The selected values are immediately accepted and stored by the unit.
7.3.3 Adjusting the colour temperature
• Press the <ON> (2) button on the remote control to switch the light on.
• Increase the colour temperature value of the fixture by pressing the plus button <CT+> (10)
on the remote control.
• Decrease the colour temperature value of the fixture by pressing the minus button <CT-> (9)
on the remote control.
• The colour temperature can be adjusted in steps of 100 from 3000 to 6000 Kelvin.
• The selected values are immediately accepted and stored by the unit.
• Press the <Section> (11) button to switch between 3 preset colour temperatures.
7.3.4 Setting the strobe function
• Press the <ON> (2) button on the remote control to switch the light on.
• Press the <Auxiliary> (8) button on the remote control.
• The light goes out briefly and then comes back on to create a flash effect.
• This function can be repeated as often as necessary.
8.
Transporting, storing the unit
WARNING
Fire hazard due to hot unit parts. Let the unit cool down completely.
• Switch off the unit (see Switching on the unit, switching off).
• Let the unit cool down completely
• Disconnect the mains cable from the unit
• Clean the unit if necessary (see Cleaning the unit)
• Place the unit and all dismantled elements in the item packaging and transport or store
according to the specifications in the technical data (see technical data).
33
Werbung
Inhaltsverzeichnis
