Setting The Rgb Mode; Setting The Fun Mode - Walimex Pro NIOVA 120 Plus-Serie Gebrauchsanleitung

NOTICE
Adjusting the colour temperature is not possible with luminaires that only have the
Daylight version, not possible.

8.8.4 Setting the RGB mode

• Press the ON / OFF button on the remote control once briefly to activate the remote control.
• Make sure that the unit and the remote control are correctly connected and set to the same
channels (see previous section 8.8.1)
• Press the mode selection button once briefly until CCT appears in the display.
• Set the desired value for the RGB colour of the fixture by pressing the plus <+> or minus <->
buttons on the remote control. The first time you set a new value, the values on the fixture are
automatically synchronised with the settings on the remote control.
• The colour temperature of the luminaire changes and the selected values are shown
synchronously on the displays of the luminaire and the remote control.
• The RGB colour setting can be adjusted in steps of one from 1 to 360
• Set the black marker to the brightness by pressing the <up> or <down> button.
• Set the desired value for the brightness of the fixture by pressing the plus <+> or minus <->
buttons on the remote control. The first time you set a new value, the values on the fixture are
automatically synchronised with the settings on the remote control.
• The luminosity of the lamp changes and the selected values are shown synchronously on the
displays of the lamp and the remote control.
• The luminosity can be adjusted in 1 % steps from 10 to 99 %.
• - The selected values are immediately accepted and stored by the unit.
• Set the black marker to the colour saturation <SAT> by pressing the <up> or <down> buttons.
• Set the desired value for the colour saturation of the fixture by pressing the plus <+> or minus
<-> buttons on the remote control. The first time you set a new value, the values on the fixture
are automatically synchronised with the settings on the remote control.
• The colour saturation of the lamp changes and the selected values are shown synchronously
on the displays of the lamp and the remote control.
• The colour saturation can be adjusted in 1% steps from 10 to 99 %.
• The selected values are immediately accepted and stored by the unit.
NOTICE
RGB mode is not possible for luminaires without RGB properties.

8.8.5 Setting the FUN mode

• Press the ON / OFF button on the remote control once briefly to activate the remote control.
• Make sure that the unit and the remote control are correctly connected and set to the same
channels (see previous section 8.8.1)
• Press the <FUN> mode start button once briefly to switch to "FUN" mode.
• Set the black marker to the currently active FUN mode by pressing the <up> or <down> buttons.
• Select the desired FUN mode by pressing the plus <+> or minus < - > buttons < - > on the
remote control. The first time you set a new value, the values on the fixture are automatically
synchronised with the settings on the remote control.
49