Operating The Device; Switching The Unit On/Off; Power Switch Of Af Assist Beam; Channel Settings - Walimex Pro W1 TTL T-F Gebrauchsanleitung

7. Operating the device

7.1 Switching the unit on/off

Slide the Power Switch to ON, and the device is on and Status Indicator Lamp will
not blink.
In order to avoid power consumption, turn off the transmitter when not in use.

7.2 Power switch of AF assist beam

Slide the power switch to ON, and the AF lighting is allowed to output. When the
camera cannot focus, the AF assist beam will turn on; when the camera can
focus, the AF assist beam will turn off.

7.3 Channel settings

1. Short press the <CH/OK> Button until the channel amount blinks.
2. Turn the Select Dial to choose the appropriate channel. Press the <CH/OK>
Button again to confirm the setting.
3. This flash trigger contains 32 channels which can be changed from 1 to 32.
Set the transmitter and the receiver to the same channel before usage.
35
705_walimex pro Funkauslöser W1 TTL T-F_BDA.indd 35
NOTICE
CH
3/14/2018 10:20:20 AM