• Set the black marker to brightness by pressing the <up> or <down> buttons.
• Set the desired value for the brightness of the fixture by pressing the plus <+> or minus <->
buttons on the remote control. The first time you set a new value, the values on the fixture are
automatically synchronised with the settings on the remote control.
• The luminosity of the lamp changes and the selected values are shown synchronously on the
displays of the lamp and the remote control.
• The luminosity can be adjusted in 1 % steps from 10 to 99 %.
• The selected values are immediately accepted and stored by the unit.
• Set the black marker to the frequency of the FUN mode by pressing the <up> or <down>
buttons.
• Set the desired value for the frequency by pressing the plus <+> or minus <-> buttons on the
remote control. The first time you set a new value, the values on the fixture are automatically
synchronised with the settings on the remote control.
• The frequency can be set in steps of one from 1 to 9. The higher the value, the higher the
frequency of the light flash.
• The selected values are immediately accepted and stored by the unit.
9.
Transporting, storing the unit
WARNING
Fire hazard due to hot unit parts. Let the unit cool down completely.
• Switch off the unit (see Switching on the unit, switching off).
• Let the unit cool down completely
• Disconnect the mains cable from the unit
• Clean the unit if necessary (see Cleaning the unit)
• Place the unit and all dismantled elements in the item packaging and transport or store
according to the specifications in the technical data (see technical data).
50