Set The Brightness ( 1-100%) On The Glowstick; Set The Colour Temperature ( 3200-7500K) On The Glowstick; Setting The Lighting Effect ( 1-9) On The Glowstick; Transporting Or Storing The Glowstick - Walimex Pro RGB TUBE SMALL M10 Gebrauchsanleitung

7.3 Set the brightness ( 1-100%) on the glowstick

1. Switch on the glowstick as described in the chapter 6.
2. Press the F (8) button 1× briefly to select the brightness setting mode
- The display shows HSI in the upper line of the display.
3. Press the adjustment knob + or – (6) repeatedly, until the desired brightness ( 1-100%) is
displayed.
- The selected brightness is shown in the bottom line of the display (4).

7.4 Set the colour temperature ( 3200-7500K) on the glowstick

1. Switch on the glowstick as described in the chapter 6.
2. Press the M button (5) until the colour temperature mode CCT is shown on the top line of
the display
3. Press the adjustment knob + or – (6) repeatedly until the desired colour temperature
( 3200-7500K) is displayed.
- The selected colour temperature is shown in the middle line of the display (4) .
7.5 Setting the lighting effect (
1. Switch on the glowstick as described in the chapter 6.
2. Press the M button (5) repeatedly, until the light effect mode MLM is displayed in the upper
line of the display.
3. Press the adjustment knob + or – (6) repeatedly until the desired light effect (
displayed.
- The selected light effect (1 Interval flash, 2 Continuous flash, 3 Screen simulation,
4 Low RGB light, 5 High RGB light, 6 Candlelight simulation, 7 Police car, 8 Ambulance,
9 Fire truck) is shown in the middle line of the display (3).
4. To end the selected light effect, press the M button (5) briefly once.
8.

Transporting or storing the glowstick

1. Switch off the glowstick. To do this, move the on/off switch (7) to the position [OFF].
2. Pull the mains plug of the adapter out of the socket or the charging cable out of the PC or
similar.
1-9) on the glowstick
1-9) is
25