Fittings - effeff 809 Montageanleitung

If the striking plates are produced by the customer or milled of the frame profile the measu-
rements are based on the following drawings.
A reliable function of the lock is only guarantueed if all regulations are observed.
b o l t c u d e a d t o u t b o l t c u l a t c h i a r y l a t a u x i l o f r a n g e m m 1 2 t o u t c h b o l t
m 1 0 m
2.3.3.2 Striking Plates Delivered by the Customer
For the design of the outer shape of
the striking plates the following must
be observed:
• When closing the door latch bolt
and auxiliary latch bolt of the lock
must be pushed back by the sa-
me edge.
• When closing the door latch bolt
and auxiliary latch bolt must be
able to slide without hindrance o-
ver an even surface into the lo-
cking position. Slots of the profile
as well as other unevenesses
must be covered by the striking
plate.
• The range of auxiliary latch bolt
must totally be integrated into the
striking plate. Neither bore holes
for fixing screws nor slots may be
in this range.
• The distance between faceplate
and striking plate may not exceed
4 mm.
38

2.3.4 Fittings