Installing The Indoor Unit - Mitsubishi Heavy Industries Mr. SLIMPSA-M KA-Serie Installationshandbuch

3. Installing the indoor unit
1
3
5
7
en
A
1
B
C
D
E
4
2
4
6
8
WARNING
Fig. 3-1
2
Base
Floor hole for fixing
Fig. 3-2
3.1. Check the indoor unit accessories
The indoor unit is supplied with the following spare parts and accessories.
Part number Accessory name
Tip-over prevention bracket
1
Tapping screws (with washer)
2
Gas pipe insulation (large)
3
Liquid pipe insulation (small)
4
Band
5
Drain socket
6
Bushing (for the wire hole)
7
Breaker notice, label
8
1
3.2. Tip-over prevention bracket (Fig. 3-2)
To prevent the unit from tipping over attach the tip-over prevention bracket to the wall.
1 Tip-over prevention bracket
F
A Tapping screws 4 × 10 (with washer)
B The long edge of the unit
C The short edge of the unit
The tip-over prevention bracket 1 is set on the top surface of the unit. Remove the
tapping screws 2, and then reinstall the bracket, as shown in the illustration. For the
proper installation distances, see Fig. 3-3.
D Screw
E Remove the screw D and then pull the grill forward to remove it.
Example of a tip-over prevention bracket
If the wall or floor is made of a material other than wood, use a suitable device such
as a commercially available concrete anchor to hold the unit in place.
G
2 4 × 25 tapping screws
F Hold the bracket in place with the tapping screws 2.
G The bottom of the unit can be held in place by four anchor bolts which can be obtained locally.
Q'ty Setting location
The top surface of
1
the unit.
3
1
1
Inside the air intake
5
grill.
1
2
1